Part Number	Metric Equiv.	Knurl TPI	A	B	D	Recommended Hole Data
						E*	F*	G Min
SW256-1	M2x0.4	50	.141	.115	.123	.118	.123	.145
SW440-1	M3x0.5	40	.172	.135	.157	.153	.159	.165
SW632-1	M3.5x0.6	40	.219	.150	.203	.199	.206	.188
SW832-1	M4x0.7	35	.250	.185	.230	.226	.234	.218
SW1024-1	———	35	.297	.225	.272	.267	.277	.255
SW1032-1	M5x0.8	35	.297	.225	.272	.267	.277	.255
SW25020-1	M6x1.0	25	.375	.300	.354	.349	.363	.335
SW25028-1	———	25	.375	.300	.354	.349	.363	.335
SW31218-1	M8x1.25	25	.468	.335	.438	.431	.448	.367
SW31224-1	———	25	.468	.335	.438	.431	.448	.367
SW37516-1	M10x1.5	20	.563	.375	.531	.523	.540	.406
SW37524-1	———	20	.563	.375	.531	.523	.540	.406

Part Number	Metric Equiv.	Knurl TPI	A	C	D	Recommended Hole Data
						E*	F*	G Min
SW256-2	M2x0.4	50	.141	.188	.112	.107	.123	.218
SW440-2	M3x0.5	40	.172	.219	.146	.141	.159	.250
SW632-2	M3.5x0.6	40	.219	.250	.190	.185	.206	.281
SW832-2	M4x0.7	35	.250	.312	.213	.208	.234	.343
SW1024-2	———	35	.297	.375	.251	.246	.277	.406
SW1032-2	M5x0.8	35	.297	.375	.251	.246	.277	.406
SW25020-2	M6x1.0	25	.375	.5000	.332	.321	.363	.531
SW25028-2	———	25	.375	.500	.332	.321	.363	.531
SW31218-2	M8x1.25	25	.468	.563	.406	.401	.448	.593
SW31224-2	———	25	.468	.563	.406	.401	.448	.593
SW37516-2	M10x1.5	20	.563	.625	.493	.488	.540	.656
SW37524-2	———	20	.563	.625	.493	.488	.540	.656
*Plus or minus .001		Metric Example: SWM5-2 Also Available in Stainless Steel Example: SW832-1SS — SW832-2SS

Notes: Thread Spec. Per MIL-S-7742. Brass per ASTM-B-16. Dimensional Limits +.005, unless specified. Class 3A/4H screw, must pass with finger torque, but basic go gauge may stop at last thread. (Applies to Stainless Steel Only) **When installing inserts into a boss, the minimum diameter “H” of the boss should be at least 1.5 times the diameter of the insert.